the "cat puzzle" keychainBy Cults on February 25, 2019 20:20
I present you the keychain "cat puzzle"
I created this key ring because the rabbit having success I thought why not make other animals
the "cat puzzle" key ring measures 6 cm by 5.5 cm and 2.7 mm deep, printing time 53 min
On the picture I printed "skin" on bluish black (with my cr10, in the middle of the printing time, I changed the filament, put purple (for example) and restarted)
the puzzle key ring is very funny to make but not very practical: -) you will have to deburr very slightly each end for a better insertion, but be careful too much deburring and more hooks possible.....
when you have printed 50% of the print on cr10 press the button
then "change filament"
switch on another coil
and press the button again
the impression this relaunch...... good impression