All categories

Loading ...

V-Block V-Block

V-Block

By MyMiniFactory on February 25, 2019 23:12

This is a simple v block, I designed it for using to saw tubing. To prevent it sliding around when sawing, the bottom edge has a lip to allow it to locate on the edge of a table or sawhorse etc. It is surprisingly tough even with 15-20% infill and 3 shells (1.2mm)
This is a simple v block, I designed it for using to saw tubing. To prevent it sliding around when sawing, the bottom edge has a lip to allow it to locate on the edge of a table or sawhorse etc. It is surprisingly tough even with 15-20% infill and 3 shells (1.2mm)